Emerson Bristol ControlWave Express Manuale delle Istruzioni Scaricare il pdf (Pagina 51)

ControlWave Express Instruction Manual (CI-ControlWave Express)

Installing the RTD

Probe

To install the RTD probe, screw the fitting body into the thermowell

with a 7/8” open-end wrench. While you apply pressure against the

sheath to force the tip of the RTD probe into the bottom of the

thermowell (so that the probe tip is in contact with the bottom of the

thermowell), tighten the 9/16” nut using an open-end wrench against

the 7/8” fitting body.

Figure 3-5. RTD Probe Installation/Removal Diagram

Software Configuration

To use data from the RTD you must include a CWM_ECPU board in

your ControlWave project using ControlWave Designer’s I/O

Configurator, and then configure it. See the ControlWave Designer

Programmer's Handbook (D5125) for more information. That same

manual includes an I/O Mapping section that describes, for advanced

users, the I/O map for this module.

Revised Mar-2011 I/O Configuration and Wiring 3-13

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 87 88

Nessun commento

Emerson Bristol ControlWave Express Manuale delle Istruzioni Pagina 51