Emerson 5081-T Specifiche Scaricare il pdf (Pagina 13)

?DECF4E:@?)966E **

LIQ_MAN_ABR_5081T-HT/Rev. L January 2015

Maintenance

%,(,-

his section gives general procedures for routine mainte-

nance of the 5081-T transmitter. The transmitter needs

almost no routine maintenance.

*($)#**(#$*$$

Periodically clean the transmitter window with household

ammonia or glass cleaner. The detector for the infrared

remote controller is located behind the window at the top

of the transmitter face. The window in front of the detec-

tor must be kept clean.

Most components of the transmitter are replaceable. Refer

to figure below and table on next page for parts and part

numbers.

+(IA=@565,:6H@7#@56=***C2?D>:EE6C

Three screws (part 13 in the drawing) hold the three cir-

cuit boards in place. Removing the screws allows the dis-

play board (part 2) and the CPU board (part 3) to be easily

removed. A ribbon cable connects the boards. The cable

plugs into the CPU board and is permanently attached to

the display board. A 16 pin and socket connector holds the

CPU and analog (part 4) boards together. Five screws hold

the terminal block (part 5) to the center housing (part 7),

and the 16 pins on the terminal block mate with 16 sock-

ets on the back side of the analog board. Use caution

when separating the terminal block from the analog

board. The pin and socket connection is tight.

1 2 ... 8 9 10 11 12 13 14 15 16

Nessun commento

Emerson 5081-T Specifiche Pagina 13